TBOX Timer 8H - 8 x 600-630 W with Heating Activator

TBOX INSTRUCTION MANUAL The TBOX® is a multi-base timer box that controls a maximum of 4 x 600W or 6 x 400W accessories. It incorporates an auxiliary heating socket located at the top, which is activated when the other sockets are off, allowing us to maintain the ideal room temperature using a heater. 1.1 TECHNICAL DATA Dimensions: 241 x 180 x 95 mm. Power required: 230 Vac / 50 Hz. Maximum power: 2,400 W. Maximum auxiliary socket power: 2,400 W. Analog timer 1.2 POWER REQUIRED To connect the TBOX® you will need two independent power lines, at least 15 amps each. Independent power lines are considered those that can be used exclusively for the TBOX®. 1.3 INSTALLATION Remove the front panel of the TBOX®, by removing the 4 plastic screws in the corners of the front. In each corner of the inside of the box you will find indentations to facilitate its fastening, install it on a smooth surface with the help of 4 screws. Mount the TBOX® near your independent power lines. At the bottom of the TBOX® you will find two power cables (230V) with earth connection. Connect an earth wire to the power line, if necessary. Now connect the plug of each of the two power cables to the power socket of your independent power line. The two connection cables are distributed by two independent power lines. Your TBOX® is connected to the mains. 1.4 CONNECTION TIPS Once you have followed steps 1.2 and 1.3, you can connect the accessories to the TBOX®. Carefully read the instructions for the accessories you wish to connect to avoid any connection errors. 1.5 EQUIPMENT SETUP FOR USE When the accessories are connected to the TBOX®, remove the plastic cover from the clock. On it, you will find a switch with three positions: Continuous on. On for selected hours. Off. Set the switch to the “on for selected hours” position. Set the time you want the equipment to turn on, by pulling the pins when the equipment is off. Pins out, equipment on. The minimum change time (off/on) is 15 minutes, equivalent to one pin. 1.6 SAFETY The operation of the TBOX® is only guaranteed if the instructions in this manual are followed. We recommend that an authorized installer install the TBOX®. Before installation, disconnect it from the 230 V power outlet. TBOX® products have a one-year warranty. To make use of this warranty, you must return the equipment to the point of sale where you purchased it. Any alteration to the TBOX® without prior consent from the manufacturer voids the warranty. Incorrect installation voids the warranty. The manufacturer, importer, and point of sale of the equipment are not responsible for any damage derived from the use of the TBOX®.