TBOX 12H Timer - 12 x 600-630w with Heater Activator

TBOX INSTRUCTION MANUAL The TBOX® is a multi-base timer box that controls a maximum of 4 x 600W or 6 x 400W accessories. It incorporates an auxiliary heating socket located at the top, which is activated when the other sockets are off, allowing us to maintain the ideal room temperature using a heater. 1.1 TECHNICAL DATA Dimensions: 241 x 180 x 95 mm. Required current: 230 Vac / 50 Hz. Maximum power: 2,400 W. Maximum auxiliary socket power: 2,400 W. Analog timer 1.2 REQUIRED CURRENT To connect the TBOX®, you will need two independent power lines, at least 15 amps each. Independent power lines are those that can be used exclusively for the TBOX®. 1.3 INSTALLATION Remove the front panel of the TBOX® by unscrewing the 4 plastic screws located at the corners of the front. In each corner inside the box, you will find indentations to facilitate its attachment. Install it on a smooth surface using 4 screws. Mount the TBOX® near its independent power lines. At the bottom of the TBOX®, you will find two power cables (230V) with grounding. Connect a ground wire to the power line if necessary. Now connect the plug of each of the two power cables to the power outlet of your independent power line. The two connection cables are distributed by two independent power lines. Your TBOX® is connected to the network. 1.4 CONNECTION TIPS Once you have followed steps 1.2 and 1.3, you can connect the accessories to the TBOX®. Carefully read the instructions for the accessories you wish to connect to avoid any connection errors. 1.5 SETTING UP THE EQUIPMENT FOR USE When you have the accessories connected to the TBOX®, remove the plastic cover of the clock. Inside, you will find a switch with three positions: Continuous ON. Selected hours ON. OFF. Set the switch to the "selected hours ON" position. Set the time you want the equipment to turn on by pulling the pins when the equipment is off. Pins out means equipment on. The minimum change time (off/on) is 15 minutes, equivalent to one pin. 1.6 SAFETY The operation of the TBOX® is only guaranteed if the instructions in this manual are followed. We recommend that an authorized installer install the TBOX®. Before installation, disconnect it from the 230 V power outlet. TBOX® products have a one-year warranty. To claim this warranty, you must return the equipment to the point of sale where you purchased it. Any alteration to the TBOX® without prior consent from the manufacturer voids the warranty. Incorrect installation voids the warranty. The manufacturer, importer, and point of sale of the equipment are not responsible for any damage resulting from the use of the TBOX®. GSE Timer Box 12x600w with Heating (GSE-13C) Specifications: - Brand GSE Systems - Model with heating - Timer Box 12x600W - Daily timer - 36-hour battery backup for the timer clock - Ideal in case of power failure - 1 Pole incl. 16A connector (EU) 4x600W - 1 Pole incl. 10A connector 3x600W (CH), - 230V/50Hz - Relay: 4x16A 230V - Protection class IP 40 - Relay dimensions: 230x300x110mm - Dimensions: 200x255x95mm