Jack Puck Large 2-Ton Press

The Jack Puck 2-Ton Large Cylindrical Press is an exclusive and innovative press created especially for compressing plant extracts, ideal for compacting hash to easily extract excess water and air, resulting in a compact slab. Easy to use and robust, it is equipped with a 2-ton hydraulic jack, enough to effortlessly produce slabs that are easier to store and handle, saving hours of work. This Jack Puck 2-Ton Large Cylindrical Press requires very simple maintenance; just regularly lubricate the ram or plunger, the pumping mechanism, and the saddle with a specific hydraulic jack lubricant. It should never be stored upright with the ram fully lowered, and be careful not to loosen the valve screw too much to avoid accidentally removing it. The round mold can be heated in the oven up to 100°C to facilitate compaction. Whether for pressing dry-sifted or water and ice extracted hash, the Jack Puck 2-Ton Press will be the best ally for resin extraction enthusiasts. INSTRUCTIONS FOR USE This step is optional but recommended. Heat the mold and the mold lid in the oven to a maximum of 100°C. This facilitates compression and increases efficiency. Secure the TrimPro Jack Puck 2-Ton Large Cylindrical Press to a table with the incorporated hooks. Assemble the mold in the press and insert the hash or any extract. If you have placed the mold in the oven, handle it with protective gloves to avoid burns. Before placing the mold lid, we suggest you put a piece of parchment or baking paper in between to make it easier to remove the pressed hash block later. Secure the lid with the two wing nuts. With the handle, tighten the valve clockwise. If the valve is open, the ram or plunger will not rise. Begin to compress the hash by moving the handle up and down as much as you can. With the handle, loosen the valve counter-clockwise to lower the ram or plunger. Remove the mold lid. Leave the mold in the press and secure it with the wing nuts. Retighten the valve with the handle. Move the handle up and down again so that the ram pushes the hash slab out of the mold. Release the pressure again by loosening the valve. With your fingers, lower the base of the mold before removing it from the press to make the most of any potential residue.